Magtek MAGTEK User Manual download pdf (Page 16)

MagTek Communications Protocol, Driver Reference Manual

If you wish to create an Instance at this time, make sure the “Yes, edit a Device...” selection is

active (as shown below) and then click “N

ext >”. If you will create an Instance later (by going to

the Add/Remove Programs in the Control Panel [see below]) then choose “No, skip this step”

and then click “N

ext >”.

Note

If you will be installing an USB MCP device (such as the IntelliStripe 380 USB”),

you do not need to create an Instance here. The computer will create an Instance

when the device is first plugged in. It should not be plugged into the computer,

however, until this installation is complete and the computer has rebooted.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 79 80

No comments

Magtek MAGTEK User Manual Page 16